Hi!

I'm an occasional woodworker and more frequent blacksmith. I have a furniture project that I'm laying out. From some of the previous pieces I have built, my 10" craftsman table saw is not as precise or capable of handling full sheets of 3/4" B-2 red oak veneer plywood as I need to do this project right.

I'm looking for someone who could give me access to a quality table saw with a nice blade for slicing down about 6 or 8 sheets of 4x8. I'll have the cut list complete and laid out - so it should only take about 2 or 3 hours to run the full set.

I'm located in Doraville - but can travel to pretty much anywhere in the extended metro Atlanta region. My target date/time to run this is either the evening of Friday Aug. 13th or anytime on Saturday Aug. 14th.

I'm willing to pay for shop time or trade out for some custom forged drawer pulls or similar accessories.

Thanks,
-Sean

http://www.indz.com

my Sawstop can rip up to 36 inch wide.  I'm in Dawsonville, let me know if that helps.

Stan

Stan!

Thanks for the offer - that's about 50 mile drive for me - and if it winds up being all I have available - I'll be there! -

I've got a 10" Craftsman that can handle 24" comfortably if I had a level garage - and a regular woodworking layout. To try it on my setup with rollers to support the full plywood sheet takes a lot of time and luck to get things to feed straight and true.

I'll ping you a little later next week to set up a time if something closer doesn't get offered. Your generous offer is appreciated.

Thanks,
-Sean

I've got a Powermatic 66 with a 50" accu-fence in my wood working shop in Gillsville (30549) about an hour away from Doraville along with a just sharpened veneer blade and a zero clearence insert which should do the job.       Give me a call if you're still looking.
Spencer
706-207-1080
http://www.waterwheelplace.com